Adjusting The Shift Pedal (FJR13A)

CHASSIS

EC3P61029

CAUTION:                                                           Direction “a”
Make sure that the main switch is turned to                         Shift pedal is raised.
“OFF” before checking the operation of the                         Direction “b”
hydraulic unit.                                                     Shift pedal is lowered.
k. After operating the ABS, repeat steps (e) to
                                                          NOTE:
   (i), and then fill the brake master cylinder res-
   ervoir or brake fluid reservoir to the proper              Check that the groove “c” in the shift pedal is be-
   level with the recommended brake fluid.                    tween the projections “d” on the frame.
l. Tighten the bleed screw to the specified
   torque.                                                                                    1
                                                                                        a
                Brake caliper bleed screw
       T.
           R.
                 6 Nm (0.6 m·kg, 4.3 ft·lb)
                                                                           2       b
m. Fill the brake master cylinder reservoir or                                                    d
   brake fluid reservoir to the proper level with
                                                                                   c
   the recommended brake fluid.
   Refer to “CHECKING THE BRAKE FLUID
   LEVEL” on page 3-29.                                       c. Tighten both locknuts to specification.
EWA14020

       WARNING
                                                                               Locknut
After bleeding the ABS, check the brake op-                          T.
                                                                      R.
                                                                                7 Nm (0.7 m·kg, 5.1 ft·lb)
eration.
                                                              ▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
                                                              ET3P66029
EAS21380
                                                              ADJUSTING THE SHIFT PEDAL (FJR13AE)
ADJUSTING THE SHIFT PEDAL (FJR13A)
                                                              1. Check:
1. Check:
                                                               • Shift pedal position
 • Shift pedal position
   Check that the center of the shift pedal end           NOTE:
   “1” is aligned with the center of the middle               The shift pedal “1” can be adjusted to three po-
   gear case cover bolt “2” as shown in the illus-            sitions to suit the rider’s preference as shown.
   tration when viewed directly from the side.
   Incorrect → Adjust.

                                                              2. Adjust:
                                                               • Shift pedal position
2. Adjust:                                                    ▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
 • Shift pedal position                                       a. Remove the shift pedal “1” by removing the
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼                                 shift pedal bolt “2”.
a. Loosen both locknuts “1”.
b. Turn the shift rod “2” in direction “a” or “b” to
   obtain the correct shift pedal position.

                                                       3-32